Slab Leak Detection in Longview, WA

Precise Slab Leak Detection Services in Longview, WA

Emergency Slab Leak Response in Longview

A slab leak that is flooding floors or causing water to bubble up through tile needs fast attention. We respond quickly, help you shut off the water and isolate the leaking side if possible. That often lets you keep some water service until the repair. Then we locate and fix the leak.

Non-Invasive Leak Detection in Longview, WA

Our primary goal is to locate your slab leak with the least amount of disruption possible. We favor non-invasive techniques like acoustic and thermal imaging before considering any intrusive methods. This approach saves your home in Longview, WA from unnecessary damage, preserves your landscaping and lowers the overall cost and time of the repair process.

Water and Sewer Line Slab Leaks in Longview, WA

Slab leaks can affect both freshwater supply lines and sewer drain pipes. Our detection services are set up to identify both types of leaks, which present different challenges. Sewer line leaks often involve foul odors and slow drainage, while water line leaks can appear as wet spots or high water bills in your Longview, WA home. We have specific methods for each.

Electronic Leak Detection in Longview

For hard-to-find leaks, our electronic leak detection equipment sends a signal through your pipes and measures changes that indicate a breach. This technology allows us to locate leaks in many pipe materials, including copper, PEX and PVC, commonly found in Longview homes. It helps prevent exploratory digging, saving you time and money.

Slab Leak Reroutes in Longview

Rerouting abandons the leaking line under the slab and runs new pipe through the walls or attic. It avoids breaking concrete and often costs less than direct access under finished floors. We typically use PEX for reroutes because it handles heat and resists hard-water corrosion. This option is popular when the slab is covered in tile or hardwood.

Hot Water Slab Leak Detection in Longview

Hot water lines leak under slabs more often than cold lines because heat speeds up corrosion and causes expansion and contraction. Signs include warm spots on the floor, a water heater that runs constantly and higher gas or electric bills. Thermal imaging shows the heat pattern spreading through tile or concrete. We confirm with a pressure test and acoustic listening before marking the spot.

Repiping After Multiple Slab Leaks in Longview, WA

If your home has had two or more slab leaks, the remaining pipe is likely corroded too. Repiping replaces all supply lines with new PEX or copper run through the walls and attic. It is a bigger project, but it ends the cycle of recurring slab leaks. We can typically complete a full repipe in two to four days.

Cold Water Slab Leak Detection in Longview, WA

Cold water slab leaks do not create warm spots, so they are more difficult to see. They often show up as a running water meter, damp carpet, a musty smell or water seeping at baseboards. We isolate the cold side and use acoustic equipment to listen for the leak through the slab. Line tracers map the pipe route so we know exactly where to listen.